Installation and Setup
BLUEPOD TECHNICAL SERVICE
Tel: 1800 800 255 Email: [email protected]
Copyright Bluepod Coffee Co Pty Ltd
Page 10 of 12
LB3200 Colibri
DATE OF ISSUE: 27/01/2011
4. On the inside of the door are 2 buttons, the left button is the rinse button.
5. Ensure the display reads “Ready for use”. Press the rinse button, this will rinse the
mixing bowl and pipes as well as rinsing the filter in the coffee brew unit. You should
see hot water pouring out of the water spouts into the waste tray. Once it has stopped,
press again to repeat this process.
6. Remove the drip tray and clean. Lift the tray at the front and pull towards yourself. The
drip tray can be separated for cleaning by pressing the two release tabs located at the
rear of the tray.
Do not wash in a dishwasher,
this will damage the tray. Refit and
replace drip tray making sure the waste hole aligns with the waste pipe.
7. Open the bottom cabinet using the round security key.
8. Empty the white plastic used pod container which sits in the upper section of the bot-
tom cabinet, clean and replace.
9. Empty waste container in the lower section, clean and replace making sure that the
float/chain and the drain hose both inside the waste container.
10. Close the base cabinet. Store the round key inside the top cabinet, the small grey
storage drawer is ideal. Remove the yellow service key and store with the cabinet key.
Close the top door and store the key safely.
11. The machine will now self test and heat. Please wait for the LCD to show “Ready for
use”
