![background image](http://html1.mh-extra.com/html/lava/premium-x-v-100/premium-x-v-100_manual-and-safety-instructions_3889784018.webp)
34
35
1. Hold the smooth vacuum bag with your thumb and index finger on the
left and right sides of the bag opening.
2. Then, simultaneously slide both thumbs to the left without changing the
position of the index fingers. The bag foil will slide over the left side seam
and automatically over the right seam as well (see Fig. A). An overlap will
be formed at the edges of the bag opening.
3. Place the bag with the overlap under the stop bar (Fig. B). The bar will
hold the edge of the bag in this position, and the air can be suctioned out
through the overlap on the left and right sides.
4. Now start in manual mode, start suctioning the air by pressing on the
device flap with enough force until a vacuum is created and the flap stays
closed on its own. The process may take a bit longer than with textured
bags since the air is only suctioned out from the sides.
5. Once the maximum vacuum is reached, the welding process can be
initiated.
7.2 Use of vacuum rolls
1. Connect the device to a 230-volt power outlet and switch the ON/OFF
Fig. A
Fig. B
switch (Fig. 2, No. 1) to . The selector switch will now light up, indicating
that the device is ready for operation.
2. Set the desired welding time on the control knob (Fig. 2, No. 2) (see 6.2)
3. Set the selector switch for containers/bags (Fig. 2, No. 7) to .
4. Open the device flap and place the open side of the roll under the bag
stop bar (Fig. 1, No. 6) until it reaches the stop. Make sure that the foil does
not have any waves.
Tip
Do not separate the bag from the roll in advance and place the end
of the continuous roll into the bag stop bar for sealing. The vacuum
will create a perfect seal.
5. The device flap should be closed and pressed firmly downwards on both
sides until the flap closes automatically.
6. Once the maximum vacuum is reached, the device automatically seals the
bag. During the sealing process, the welding indicator light (Fig. 2, No. 3) will
illuminate.
7. At the end of the sealing process, the device will automatically shut off.
8. Vent the vacuum chamber (Fig. 2, No. 4).
9. Lift the device lid and remove the sealed foil. Cut the foil to the desired
length with a clean and straight cut. The self-made bag can now be
vacuumed as indicated in chapter 7.1.
Tip
The device door cannot be opened under vacuum. To terminate the
vacuuming or sealing process prematurely, turn off the device us-
ing the ON/OFF switch (Fig. 2, No. 1). Vent the vacuum chamber (Fig.
2, No. 4). The device door can then be opened again.
EN
Summary of Contents for PREMIUM X V.100
Page 24: ...Notizen Notes...