background image

 

Pa

ge

Upon  completion  of  the  installation,  you  are  required  to  fully  explain  and 
demonstrate to the user, the operational details and safety practices applicable 
to  the  appliance  and  installation  thereof.  The  appliance  has  been  specifically 
designed for use with LPG and may not be used with Town’s gas or Natural Gas. 
Read  the  instructions  carefully  before  commencing  with  the  installation. 

Pay 

particular attention to the provision of adequate ventilation as this appliance is 
designed for use without a flue

Insufficient ventilation may impair the efficient 

performance of the appliance and may endanger the lives of the occupants of 
the area of use. See Safety Information! (SEE SECTION 3

 for details). 

3.

 

SAFETY INSTRUCTIONS

 

 

Do not use this appliance if it is leaking gas. (See notes below). 

 

If there is an apparent gas leak (smell of gas), close the control valve on the 
appliance. 
Make sure that there are no naked flames within 5-meters of the appliance and 
check for leaks as described below. 

 

Never check for gas leaks with a naked flame as this is extremely dangerous! 

 

To check for a gas leak, use a brush dipped in a soapy water solution (e.g. water 
with a dishwashing detergent added) and apply the solution to all the joints of 
the system. If there is leak, turn off the gas supply at the isolation valve, which 
the installer will provide as part of the installation. Call a service technician to 
examine the appliance and do not use the appliance until the service technician 
has declared that it is safe to do so. 

 

Should you suspect a leak at the cylinder connections (outside the building) 
apply the soapy water solution to the visible joints, such where the regulator 
fits into the cylinder, or where the regulator fits into the flexible hose, or the 
joints on the manifold, if fitted. Bubbles will form should there be a leak. If you 
are unable to stop a leak at this point, turn off the cylinder valve/valves and 
call a service technician to correct the fault. As with leaks inside the building, 
do not use the appliance until a service technician as declared that it is safe to 
do so. 

 

Ensure that the appliance is used away from flammable materials. If installing 
in an open area without a firebox, ensure that the surrounding area is clear of 
any flammable material for a minimum of 1 meter all-round the appliance. 

 

Keep young children away from the appliance when in use.  

Summary of Contents for FGW 003













Reviews: