58
LAUNCH
X-431 PAD V
User's Manual
following figure. Users can adjust capacity size by tapping on < or >
or by dragging the slider on the bar.
Fig. 7-16
If JIS is selected, tap , the system will enter Select testing
capacity screen. Users can select corresponding standard capacity
value according to battery model marked on battery.
7. Tap and the testing result will appear on the following screen.
Fig. 7-17
[ ]: Tap it to perform the charging system and starting system test.
[ ]: Tap to test it again.
[ ]: Tap it to reset the test.
2. Charging system and starting system test
While performing this test, the battery’s charging voltage value
and starting voltage can be obtained in case of engine starting and
accelerating. Based on the data, the system will judge whether
battery’s charging and actuation status is normal or not.
Tap in Fig. 7-17, a dialog box will pop up.
Fig. 7-18
After detecting engine starting, follow the instructions on the screen to
increase the speed.
The system begins to receive test data information after acceleration
was detected.
Fig. 7-19
Tap [OK], test data will be shown on the screen.
*Note: It is unnecessary to perform charging system and start system
test after finishing battery test, but battery test must be done before
undergoing charging system and starting system test.