Laski FZ 500 H, Operating Instructions Manual

Page: 12 / 37

1 2
(especially squeezing hazards at jib motion)
- having started the cutter the operator is not allowed to leave his cab of
a building machine and he should be permanently watching the cutting
operation
- the operator should avoid any activity which could bring hazards for himself
and other persons
- while handling the cutter, especially after its start, avoid its contact with
the building machine. The jib radius with the cutter is extended!!!
- having finished the cutting work put the cutter in its supporting frame to
ensure its stability and to avoid contact of blades with base
- to fix the cutter in its supporting frame properly
- to respect all work safety instructions for the given building machine
- It is not allowed to use the cutter, attached to the hydraulic jib, in any other way than to
purposes given by the manufacturer.
-
This manual describes also some common troubles and failures which could occur and
which are easy to be remedied by an instructed person. Other problems and faults
should be announced directly to the manufacturer who is always ready to help you.
- It is not allowed to do any technical changes or any actions which are neither given in
this manual nor allowed by the manufacturer. The machine, not correctly installed or
adjusted, may run without problems now but in the future it could bring damage any of
important parts.
- Do not put any objects or tools on the machine.
- The manufacturer does not bear responsibility for any damages or injures to the third
persons or to other equipment resulted from disobedience to instructions given in this
manual.
-
When turning off the machine keep its remote control box separately to avoid starting by
no unauthorised persons.
- When handing the machine over to another person make sure if all controls, guards and
other safety elements are complete.
-
Do not remove guards and other safety elements. They serve for your safety.
- Keep the given intervals for checks of bolted joints.
- Always after work clean all parts of the machine with pressure water.
- Any servicing can be done only if the machine was put out of operation, the remote
control was off and its battery was disconnected.
-
Avoid any random start - disconnect the plus pole of the battery.
- Keep all parts clean, especially cooling ducts of the engine and parts related to the fuel
tank.
- Fill up the fuel tank before working and only if the machine is turned off.
-
Do not fill the fuel tank while the engine is hot or still running.
-
Do not start if some fuel has been spilled.
-
Do not use petrol as a cleaning agent.
- Keep open fire away while filling the tank.
- Keep the machine beyond reach of open fire.
- Any transport of persons or of any load on the machine is not allowed.