Laski FZ 500 H, Operating Instructions Manual

Page: 11 / 37

1 1
Work Safety Instructions
Utilisation
This suspension cutter is designed for suspension on a hydraulic jib of building machines with
relevant fixing devices and for cutting a stump with its above-ground part and its under-ground
part in a max. depth of 20 cm under the ground level. While working the cutter must be in a
vertical position or in an angle of +/-30
o
to its vertical axle.
Not Allowed Use
This machine cannot be used for cutting of dozy stumps which could be released and pulled
out by the blades. Avoid any cutting if there can be stones, metallic and glass objects etc.
hidden in the stump.
It is not allowed to use the cutter for cross-cutting, felling, cutting branch wood off etc.
It is also not allowed to use the cutter if the operator of a building machine have no view to the
cutting blades.
Generally
- This machine can be operated only by an operator that is over 18 yrs old, physically and
mentally capable and demonstrably instructed with its operation.
-
Keep this machine beyond children's and unauthorised person's reach. Avoid their
attendance while cutting.
- The operator of this machine is fully responsible for any injury or damage caused to the
third persons within the operating reach of the machine.
-
Before working learn all functions of individual controls. If necessary, contact your dealer
and ask him for operator's training.
- Operation of the hydraulic jib, especially its motional continuousness and co-ordination,
requires considerable experiences.
- At work in residential zones use the machine in accordance with regulations of the local
authorities to avoid disturbing of local inhabitants.
-
The operator is obliged:
- to use only a such building machine which is in optimal operating condition,
without excessive jib clearances
- to use only a such building machine which is provided with a cab with
undamaged windows for his protection against operating noise
- to use only an original fixing device, designed for such purpose and supplied
by the manufacturer. This fixing device must be properly bolted to the jib. It
is necessary to check bolted joints regularly after longer operation.
- for remote control of the cutter to use only a such equipment which is
provided with ON/OFF and CENTRAL STOP controls
- to install functional controls on the jib so that their damage may be excluded