![background image](http://html.mh-extra.com/html/larson-electronics/ind-md-tm-cs-th-kt/ind-md-tm-cs-th-kt_instruction-manual_677018014.webp)
IND-MD-TM-CS-TH-KT
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
14 of 21
Figure 4-4 List of other device
Device management interface specific operation instructions are as follows
:
1. Search device: click this button to search online devices and showing device info automatically.
2. Add device: after checking the device info, click this button to this device record will be saved in database.
3. Delete device
:
click this button to delete device info from database of chosen device.
4. Add device in other device list: Used to input the IP address if NVR.
4.2 System Setting
System settings including alarm setting, shield area, blackbody area, image synchronization and other, totally six
settings to adjust the parameters, below is the introduction of the each sub options.
4.2.1
Alarm parameter setting
Single
click
in
the
main
interface
“Settings”—>“System settings”—>“
Alarm parameters”, there are two modes, high-
temp alarm and low-temp alarm. High-temp alarm is used to alarm when there is higher temp than setting value this
is for human body temperature. Low-temp alarm is used to alarm when there is lower temp than setting value, this is
for lower temp objects. Setting interface is as below Fig 4-5
.
Here is showing hi-temp alarm as example: