LT-3100S GMDSS User & Installation Manual Rev. 1.02
User Interface (UI)
Lars Thrane A/S
www.thrane.eu
Page 36 of 71
System status
The LT-3100S GMDSS system installation and mounting is described in the previous sections. After the LT-
3100S GMDSS system has been installed and properly connected, the system will automatically start-up
and register on the Iridium® Network.
NOTE
:
It is assumed that the LT-3100S GMDSS System has been commissioned correctly with an
Iridium GMDSS Service Provider and that the LT-3100S Installation Wizard has been
completed successfully.
The LT-3100S GMDSS system will inform the user, if the system is not properly installed, or the system
cannot register onto the Iridium® Network. Figure 35 is illustrating a LT-3100S GMDSS system, which is
registered on the Iridium® Network and ready to use. The LT-3100S GMDSS system will provide user
information in the status bar and status text (
e.g. “Registered”
showed below the Iridium® connected logo).
The signal strength icon will be showed with a signal strength between 0 and 5 (where 5 is the maximum
signal strength), when the LT-3100S GMDSS system is registered on the network and ready to use. If no
signal is available, the signal bar symbol will be showed with no highlighted bars and a small cross. The
status text will show
“
Registered
”
, if the system is ready to use. Table 16 gives an overview of the possible
combinations, of the signal strength icon, and the status text that the LT-3100S GMDSS system can
represent.
Figure 35: LT-3110S Control Unit - UI display (status view).
Signal Bar
System Text
System Status
0 to 5
Registered
Ready to use
0 to 5
Registering…
Not ready
No bars (with cross)
Searching for Iridium…
Not ready
Table 16: LT-3110S Control Unit
–
Registration status.
Status bar
System text
