4: Advanced Operations
SLP: set email smtp port 5555<Enter>
Setting the ‘From’ email address:
The Set Email From command sets the ‘from’ email address. By default, this is set to
‘SLP3_’ plus the last three octets of the unit’s MAC address. Example:
‘SLP3_510c90@’
To set the ‘From’ email address:
At the SLP: prompt, type set email from, followed by the originating email address
and press Enter.
Example
The following command sets the ‘from’ email address to
[email protected]:
SLP: set email from [email protected]<Enter>
Setting the ‘To’ email address:
The Set Email PrimaryTo and Set Email SecondaryTo commands set the recipient
email addresses.
To set the ‘To’ email address:
At the SLP: prompt, type
set email
, followed by
primaryto
or
secondaryto
and the
destination email address. Press
Enter
.
Examples
The following command sets the primary ‘to’ email address to
[email protected]:
SLP: set email primaryto [email protected]<Enter>
The following command sets the secondary ‘to’ email address to
[email protected]:
SLP: set email secondaryto [email protected]<Enter>
Enabling or disabling event notification types:
The Set Email Event, Set Email Auth, Set Email Power and Set Email Config
commands enable or disable email notification of the event types as described on
page
95.
To enable or disable event notification types:
At the SLP: prompt, type
set email
, followed by
event
,
auth
,
power
or
config
and
enabled
or
disabled
. Press
Enter
.
Examples
The following command sets the enables email notification general system events:
SLP: set email event enabled<Enter>
The following command sets the disables email notification authentications attempts:
SLP: set email auth disable<Enter>
SecureLinx SLP Remote Power Manager
96
