SCS1600/3200 User Guide
5: Troubleshooting
Set Server Hardware xx-xx-xx
Specifies the last three numbers of the SCS's Ethernet address. The first three numbers
are supplied automatically.
The Ethernet address should have been set at the factory. Setting an incorrect address
could cause serious network problems.
Set Server IPAddress ip_address
Specifies this SCS's IP address. Uses the standard numeric format.
Set Server loadhost ip_address
Specifies the host to attempt to load the file from. The IP address should be in standard
numeric format (no text names are allowed).
Set Server RARP {Enabled, Disabled}
Enables or disables the sending of RARP queries during the boot sequence. It is enabled
by default.
Set Server Secondary ip_address
Specifies a backup loadhost. The IP address should be in standard numeric format (no
text names are allowed). The backup loadhost is queried if the primary host cannot load
the server.
Set Server Software filename
Specifies the name of the file to load. The SCS automatically adds
.SYS
to the filename
you specify. Note that all protocols must have a filename specified (either the default or
set by the user). For more information, see
Updating Software
.
TCP/IP users must use
the Software option to specify the loadhost, the loadfile, and their own network address.
TFTP users can specify a complete path name (up to 31 characters) if the file is located
in a directory other than the default. The case of the filename must match that of the
filename loaded onto the host computer.
Show Server
Use this command when issuing other commands to view the current SCS setup.
5-6