5
Hardware Setup
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING:
To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
device. The Power On/Standby button on the back
panel does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unscrew the 6 screws from the top cover of the FW-
1.
7541 System.
Open the cover.
2.
Installing the System Memory
The motherboard supports DDR3 memory that features
data transfer rates of 667/800MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications. It comes with one Double Data
Rate Type Three (DDR3) Small Outline Dual Inline Memory
Module (SO-DIMM) socket.
Align the memory module’s cutout with the the SO-
1.
DIMM’s slot notch.
Install the SO-DIMM.
2.
Note:
SO-DIMM installed must meet the following
1.
speed requirement: DDR3 667/800 MHz. Do not
install DIMMs with different speeds.
The motherboard equips with one SO-DIMM
2.
socket
—
all models can support up to 4GB
capacity in maximum .
Cutout
Notch
