6-4
F-459-R1
TRUCK LUBRICATION AND CHAIN MAINTENANCE
Figure 6-7 Lubricating Tilt Cylinder Clevis
Shift Bearing Pads
1.
Start the truck and pivot the mast 90 degrees to the
right.
2.
Shift fully to the right.
3. Turn the truck off and remove the key and place in a
secure area.
4.
Perform a Lock Out/Tag Out procedure.
5.
Apply a light coating of grease to the bottom slide
bearings. Apply a light coating of grease to the upper
channel. See Figure 6-8.
6.
Start the truck and shift the mast fully to the left.
7.
Repeat steps 3 and 4.
8.
Apply a light coating of grease to right side of lower
bearing and upper channel.
9.
Shift the front end fully to the left and right 2 times
and wipe up excess grease.
10. Note: For optimum performance, lubricate shift
bearing pads daily for the first 50-100 hours of truck
operation.
Figure 6-8: Shift Bearing Pads
Fork Positioner Lubrication, Non-Side
Shifting (Option)
1.
Start the truck and position the mast straight ahead.
2.
Set the key switch to OFF, remove the key from the
key switch and place in a secure area.
3.
Before lubricating the positioner rails, wipe off excess
lubricant and dirt buildup from within the rail channels
and dirt from the top and bottom of the rail grooves.
4.
Using a brush, lubricate the top areas on the fork
rails, including a thin film on the front face of both
rails. Using a grease gun apply grease to the lower
fork rails. See Figure 6-9.
5. Wipe off excess grease.
Grease Point
G
Grease Points
Grease Points
https://www.forkliftpdfmanuals.com/
