Landoll Brillion Alfalfa SS108, Operator'S Manual

Page: 41 / 92

ASSEMBLY
9K713-0522 2-25
TABLE OF CONTENTS
Console w/Clutch Control
Seed Shaft Sensor - Optional
1. Remove the two 10 x 24 x 3/4 self tapping screws
from the Magnet Wheel Assembly. Position the
rounded half of the Magnet Wheel Assembly on the
seed shaft. Ensure it fits squarely onto shaft. Mount
magnet half to the rounded half. ensure it fits squarely
onto shaft.
2. Fasten the two halves together using two #10-24 x 3/4
Self Tapping Screws. Do not over tighten .
3. Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware.
4. Insert Sensor into Shaft Sensor Bracket slot.
5. Insert a 1/4-20 x 3/4 Machine Screw into each seed
cup. Align the Shaft Sensor Bracket with the two
1/4-20 x 3/4 Screws. Secure with existing Lock
Washers and Nuts.
6. Slide/Position Seed Shaft Sensor so it is 1/8" from the
magnet. See Figure 2-33. Tighten both Retaining
Locknuts.
Figure 2-33: Console w/Clutch Control - Detail
Figure 2-34: Console w/Clutch Control - Seed Box Shaft Sensor
1/8" Max
Magnet Wheel
Assembly
Shaft Sensor
Bracket
Seed Shaft
Sensor
Magnet
Seed Shaft
Magnet Wheel
Assembly
3/8 Sq Shaft
Machine Screw,
1/4-20 x 3/4
Existing
Lock Washer,1/4-20
Existing
Nut,1/4-20
Shaft Sensor Bracket
Seed Shaft
Sensor
Screw, Self Tapping
#10-24 x 3/4
Seed Shaft
Existing
Nut,1/4-20
Shaft Sensor
Bracket
Seed Shaft
Sensor
Existing
Lock Washer,1/4
Machine Screw,
1/4-20 x 34
Screw, Self Tapping
#10-24 x 3/4
Magnet Wheel
Assembly
3/8 Sq Shaft