Section 4: Adjustments
HRS3025 Hydraulic Reservoir System 316-271M
1/16/20
27
Parking Stand Adjustments
Figure 4-1
Park Stands
Refer to Figure 4-1:
WARNING
!
Be careful not to pinch fingers or hand while raising and
lowering park stands. Hands and fingers can become pinched
in the slide tubes or caught between the reservoir tank and
stands.
The four park stands (#1) should be fully raised for
working and while transporting. Make sure wire retaining
pins (#2) are fully inserted in hole (A) and wire retainers
are caught over the pins.
The four park stands (#1) should be lowered and pinned
with the wire retaining pins (#2) when unhooking for
storage. Because the unit contains 35 gallons of
hydraulic fluid, it is best to secure park stands in
hole “B”. The unit will be more stable in this hole. If this
height is too low for unhitching and re-hitching, then use
holes “C” or “D” as needed. Make sure hitch pins are in
the same holes on all four legs.
30396
Tractor 3-Point Hitch
Figure 4-2
Leveling Adjustments
Refer to Figure 4-2:
CAUTION
!
Always keep your feet and legs out from under the Hydraulic
Reservoir System. Never work under the Hydraulic Reservoir
System without properly blocking the reservoir up.
Check for levelness by parking tractor on a level surface.
Lowering Hydraulic Reservoir down until unit is 2 to 3 feet
off the ground. Place tractor in park or set park brake,
shut tractor off, and remove switch key.
1. Place a level across the reservoir tank. Manually
adjust one of the two lower lift arms up or down to
level the Hydraulic Reservoir from left to right.
2. Rotate level 90 degrees. Manually adjust the length
of the top center 3-point link to level the Hydraulic
Reservoir from front to rear.
37298
NOTE:
See Tractor Operator’s Manual for
instructions on how to adjust tractor’s lower 3-point
arms and top center link.
Section 4: Adjustments
