Land Pride HRS3025, Operator'S Manual

Page: 21 / 44

Section 2: Hook-up to Reservoir
HRS3025 Hydraulic Reservoir System 316-271M 1/16/20
17
Table of Contents
Driveline Hook-Up
Refer to Figure 2-2:
DANGER
!
To avoid serious injury or death:
•
Tractor power take-off shaft shield, driveline shields, and
gearbox shaft shields must be installed and in good working
condition to avoid driveline entanglement and projectiles
flying off of the driveline.
•
Do not engage power take-off while hooking-up or
unhooking the driveline, or while someone is standing near
the driveline. A person’s body and/or clothing can become
entangled in the driveline.
•
Do not use a power take-off adapter. The adapter will
increase strain on the tractor’s power take-off shaft causing
possible damage to shaft and driveline. It will also defeat
the purpose of the tractor’s power take-off shield.
•
Make certain driveline yokes are securely fastened at each
end. A loose yoke can work free allowing the driveline to
rotate uncontrollably causing implement damage and
bodily injury or death to anyone nearby.
WARNING
!
To avoid serious injury or death:
•
Always follow “Tractor Shutdown Procedure” provided in
this manual before dismounting the tractor.
•
Check driveline when lowering implement to make sure it
does not interfere with the tractor drawbar at maximum
depth. If needed, shut tractor off and move or remove
drawbar to prevent driveline damage.
1. If driveline collapsible length has not been checked,
go to
“Check Driveline Collapsible Length”
on
page 18. Otherwise, continue with step 2 below.
2. Park tractor and reservoir on a level surface.
3. Shut tractor down before dismounting. Refer to
“Tractor Shutdown Procedure”
on page 16.
4. If tractor drawbar interferes with the driveline during
hook-up, disconnect driveline and move drawbar
forward, to the side, or remove.
5. Collapse driveline by pushing tractor end of driveline
toward the reservoir’s gearbox.
6. Pull back on the driveline pull collar and push yoke
onto the tractor power take-off shaft. Release pull
collar and continue to push driveline yoke forward
until pull collar pops out and locks in place.
7. Pull on driveline yokes at the tractor and reservoir
end to make sure they are secured to the tractor
power take-off shaft and reservoir’s gearbox shaft.
8. The tractor’s lower 3-point arms should be adjusted
for lateral float. Please consult your tractor’s manual.
9. Continue with “Check Driveline Interference” on
page 19.
IMPORTANT: An additional driveline may be
required if implement is attached to more than one
tractor or if a Quick Hitch is used.
IMPORTANT: Check driveline minimum collapsible
length before completing
“Driveline Hook-Up”
.
Structural damage to the tractor and reservoir can
occur if this check is not made. Refer to
“Check
Driveline Collapsible Length” on page 18.
3-Point Hook-Up
Figure 2-2
Quick Hitch Hook-up
Cat. I & II Top Center Link Clevis Pin
linchpins
Wire Retaining
Pins
Park Stands
Driveline
Hairpin Cotter
Lower 3-Point Hitch Pins
Cat. I
Clevises
Cat. II
Clevises
21422A
37298
Pull Collar
Top Center
3-Point Link
Power Take-off
Shaft
Drawbar
Lower 3-Point
Lift Arms