![background image](http://html1.mh-extra.com/html/land-pride/710-040m/710-040m_operation-manual_3500694006.webp)
Section 2 Important Safety Information
4200ATR Light Utility Vehicle 710-040M
7/14/08
4
Table of Contents
Practice Safe
Maintenance
▲
Understand procedure before
doing work. Use proper tools and
equipment. Refer to this manual
for additional information.
▲
Work in a clean, dry area.
▲
Place the vehicle in neutral, set
parking brake, turn off engine,
and remove key before
performing maintenance. Chock
wheels if you must perform
maintenance on a slope.
911
OFF
▲
Make sure all moving parts have
stopped and all system pressure
is relieved.
▲
Allow the engine to cool
completely.
▲
Disconnect battery ground cable
(-) before servicing or adjusting
electrical systems or before
welding.
Prepare for
Emergencies
▲
Be prepared if a fire starts.
▲
Keep a first aid kit and fire
extinguisher handy.
▲
Keep emergency numbers for
doctor, ambulance, hospital and
fire department near phone.
▲
Inspect all parts. Make sure
parts are in good condition and
installed properly.
▲
Remove buildup of grease, oil or
debris.
▲
Remove all tools and unused
parts from the All Terrain
Runabout before operation.
Wear Protective
Equipment
▲
Wear protective clothing and
equipment.
▲
Wear clothing and equipment
appropriate for the job. Avoid
loose-fitting clothing.
▲
Because prolonged exposure to
loud noise can cause hearing
impairment or hearing loss, it is
best to wear suitable hearing
protection such as earmuffs or
earplugs.
▲
Because operating equipment
safely requires your full attention,
avoid wearing radio headphones
while operating machinery.
▲
It is the discretion of the operator
and passenger to wear Seat
Belts
Tire Safety
Tire changing can be dangerous
and should be performed by trained
personnel using correct tools and
equipment.
▲
When inflating tires, use a clip-on
chuck and extension hose long
enough for you to stand to one
side–not in front of or over tire
assembly. Use a safety cage if
available.
▲
When removing and installing
wheels, use wheel-handling
equipment adequate for weight
involved.
These are common practices that may or may not be applicable to the products described in
this manual.