10
P.N. 28-0558/04
1.2 UNPACKING THE DISPENSER
A. Set the shipping carton upright on the floor.
B. Cut band, remove.
C. Open the top of the carton and remove the interior packing.
D. Lift the carton up and off the dispenser.
E. Remove the wood shipping base from the bottom of the dispenser. Support dispenser while
removing the shipping base to prevent damage to the dispenser.
1.3 DRAIN SPIDER
The drain spider is located directly in the center of the bin under the ice shroud. The coldplate has
a cavity designed to hold the drain spider. During shipment or installation, the drain spider may
become dislodged from its original position.
Prior to installing the dispenser, ensure the drain spider is in the correct position. This will prevent
drain clog issues. Inspect the lower bin area and reach under the shroud to ensure the drain spider
is secure in the coldplate cutout. If the spider is not in place, proceed with the following steps:
A. Remove agitator clip and pin from agitator bar.
B. Remove agitator bar from paddle wheel.
C. Remove paddle wheel.
D. Remove ice shroud by lifting back then out of bin.
E. Locate drain spider and reinstall in the coldplate cavity where drain line exits (see figure above).
F. Reinstall all components. Ensure agitator clip is locked:
