Vial holder
Dispenser
LOADING
1. Separate shielded vial holder from dispenser
2. Check Huber point needles inside the dispenser
to ensure that they are not blocked (if necessary,
clean by pushing a fine wire through needles)
3. Attach a hypodermic needle (or other connector)
securely to Luer Lock fitting on front end of
dispenser.
4. Remove cap of the Xenon Xe-133 lead shipping
tube, being careful to point opened tube away
from body.
5. Place the open end of the shielded vial holder
tightly against the open end of the shipping tube.
6.
Simultaneously invert both to allow one vial to
slip from shipping tube into shielded vial holder.
7.
Carefully separate the pieces shown in figure,
being certain to point the open ends away from
the body. There should be one vial in the shielded
vial holder, septum end out. Recap the lead
shipping tube.
Operation Instructions for
CALIDOSE
®
DISPENSER
for use with Lantheus Xenon Xe-133 Gas
