PAGE 1 OF 6
0421 IH-5066
1-800-295-5510
uline.com
FOAM SOAP
DISPENSER
H-5066
INSTALLATION
Do not install in locations where dispenser may be
exposed to wet environments, such as showers or areas
where walls are washed down.
PREPARING FOR INSTALLATION
1. Open dispenser by pushing on
one of the dual side latches
until it releases. (See Figure 1)
2. Install dispenser at least 6"
above counter top.
(See Figure 2)
TAPE INSTALLATION
1. Peel paper off installation tape.
Clean installation surface with
an alcohol pad. Allow surface
to dry for 60 seconds.
(See Figure 3)
2. Press firmly on back plate
for 10 seconds. For maximum
adhesion, do not load refill for
24 hours. (See Figure 4)
FASTENER INSTALLATION (NOT INCLUDED)
1. Using back plate as a template,
press a pencil through the
installation tape to mark holes.
(See Figure 5)
2. Mark and drill holes using
#10 x 1" anchors and type A
#10 x 1" screws.
BATTERY INSTALLATION
1. Open dispenser by pushing
one of dual side latches until it
releases. Use four high quality
D-Cell batteries (not included).
(See Figure 6)
2. Close dispenser. Battery
indicator light will initially
alternate blinking red and
green, and after a few
moments will consistently blink
green. (See Figure 7)
REFILL INSTALLATION
1. Remove cap from refill pump.
You will notice a colored knob
(E-key) protruding from the
black pump collar. DO NOT
REMOVE THE E-KEY. Removing
the E-key will prevent the refill
from dispensing. (See Figure 8)
2. With E-key facing the back plate,
push refill pump into pump
house. When refill is installed
correctly, indicator light will blink
green. (See Figure 8)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 7
Figure 8
TOOL NEEDED
(FOR OPTIONAL FASTENER INSTALLATION)
PARTS
(FOR OPTIONAL FASTENER INSTALLATION)
Drill
Type A
#10 x 1" Screw x 4
#10 x 1" Anchor x 4
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Figure 6
