2.
Remove drip tray and cup rest. Wash drip tray and cup rest thoroughly with warm, soapy
water using a mild detergent. Rinse thoroughly with clean, warm water and reinstall drip tray
and cup rest to dispenser.
3.
Wipe down dispenser to remove any product residue.
WARNING
REMOVE SANITIZING SOLUTION FROM DISPENSER AS INSTRUCTED. RESIDUAL
SANITIZING SOLUTION LEFT IN SYSTEM COULD CREATE HEALTH HAZARD.
CAUTION
DO NOT SOAK NOZZLES IN CHLORINE SOLUTION OVERNIGHT. THIS WILL CAUSE NOZZLES
TO SWELL AND PLASTIC WILL BEGIN TO DETERIORATE.
B. Weekly
1.
Flush each valve of dispenser until clear water flows from the nozzle.
2.
Turn off water supply to dispenser.
3.
Remove lid and wash thoroughly with warm, soapy water using a mild detergent. Rinse
thoroughly with clean, warm water.
4.
Lift up on the check valve (white or yellow elbow) to remove it from the Minute Pak
®
.
5.
Remove Minute Pak
®
from dispenser.
6.
Remove nozzles and disassemble (see NOZZLE ASSEMBLY instructions). Wash
thoroughly with warm, soapy water using a mild detergent. Rinse thoroughly with clean,
warm water and replace. DO NOT SOAK NOZZLES IN CHLORINE SOLUTION
OVERNIGHT. THIS WILL CAUSE NOZZLES TO SWELL AND PLASTIC WILL BEGIN TO
DETERIORATE.
7.
Fill the specially marked sanitizing container with 80 ounces of COOL chlorinated sanitizing
solution (Diversol CX, or equivalent) minimum 100 PPM available chlorine, but not to
exceed 200 PPM; replace sanitizing container in dispenser.
8.
Replace check valve in sanitizing container.
9.
Activate valve for two (2) minutes ensuring concentrate lines are full of solution. Let
solution stand for five (5) minutes without dispensing.
10. Perform a second two (2) minute dispense and let stand for an additional five (5) minutes.
11. Activate valve until the sanitizing solution empties from the sanitizing container.
12. Remove check valve from sanitizing container, remove container, and pour out excess
sanitizing solution.
13. Repeat for each valve.
14. Reinstall Minute Pak
®
, and replace check valves.
15. Run concentrate through valves to remove traces of sanitizing solution from the dispenser.
NOTE
Please note that a fresh water rinse cannot follow sanitization of equipment. Purge only with
the end use product.
This is an NSF requirement.
16. Remove drip tray and cup rest. Wash thoroughly with warm, soapy water using a mild deter-
gent. Rinse thoroughly with clean, warm water.
17. Wipe the dispenser with a clean damp cloth, taking care to remove all product residue.
18. Replace drip tray, and cup rest.
19. Turn on the water supply to the unit.
20. Reinstall lid.
21. Prime dispenser by holding cup under spout and activating the valve until a
concentrate/water mix is dispensed.
2.4
LIGHTED FRONT SECTION
A. Replacing Graphics in Lighted Front Section
1.
Turn the key to the “OFF” position, turn switch on inside of front cover to the “OFF” position,
and unplug unit.
2.
Open front cover and push the clear clips (protruding from the reflector) into the slots in the
reflector. Return cover to the closed position.
5
dinecompany.com