B. Remove agitator deck (see Section 6.14).
C. Remove water from ice bank compartment.
D. Loosen tubing nuts on water coil.
E. Remove four (4) nuts holding cage assembly to bottom of tank.
F.
Remove cage assembly from tank.
G. Remove defective water coil from cage assembly.
H. Reassemble cage assembly in tank by reversing procedure. Tighten water coil tubing nuts 1/4
turn after finger tight.
I.
Open inlet water shut off valve and check for leaks.
J.
Refill ice bank compartment to overflow port.
K. Replace agitator deck and lid.
6.16 FRONT COVER
CAUTION
CARE SHOULD BE USED WHEN HANDLING FRONT COVER SO AS TO NOT SCRATCH OR
MAR SURFACE. WHEN CLEANING, USE ONLY DAMP CLEAN CLOTH.
A. Lift front cover up so that it rests on top cover.
B. Loosen two (2) wing nuts
(do
not
remove)
holding retainer to front edge of top cover.
C. Slide retainer down.
D. Pull front cover forward and remove.
E. To reassemble, reverse procedure.
6.17 TOP COVER
A. Flush both sides of unit.
B. Turn key switch OFF.
C. Remove both lids.
D. Remove front cover.
E. Remove check valves from concentrate tubes.
F.
Remove concentrate containers.
G. Loosen three screws (
do
not
remove
) holding top cover to frame at
front
of unit.
H. Loosen three screws (
do
not
remove
) holding top cover to frame at
rear
of unit.
I.
Lift top cover up and off unit.
J.
To reassemble, reverse the above procedures.
6.18 WRAPPER
WARNING
DISCONNECT THE POWER CORD FROM THE ELECTRICAL OUTLET.
A. Remove front cover (see Section 6.16) and top cover (see Section 6.17).
B. Remove drip tray, dispensing paddles and splash plate.
C. Remove eight (8) screws on front of unit [four (4) on each side]. Locations are as follows.
(1) Top and bottom in flange of control housing.
(2) Two (2) in wrapper below pump support.
D. Spread wrapper at front of unit slightly on each side in order to clear frame. Push wrapper
toward back of unit until wrapper is free of frame.
NOTE
It is not necessary to remove control housing and pump support when removing wrapper.
E. To reassemble, reverse above procedure being sure that cutout for power cord in rear of wrap-
per seats properly. Clean only with damp clean cloth or approved non-abrasive spray or liquid
stainless steel cleaner.
6.19 CONDENSER FAN MOTOR
WARNING
DISCONNECT THE POWER CORD FROM THE ELECTRICAL OUTLET.
A. Disconnect fan motor electrical cord from junction box.
15
dinecompany.com
