F.
Depress the Sold Out Reset button.
G. Depress dispensing paddle with cup until a steady flow of pre-mixed product is obtained. Unit
is now ready to dispense. Install nozzles and check °Brix (see Section 1.10).
H. Change product plate on front cover to indicate new product.
NOTE
If the new product requires a different mixing ratio, see Section 1.10 (°Brix).
2.2
OPERATING ESCORT III JUICE DISPENSERS WITH SOLD OUT FEATURE
A. New Package
1.
Turn key to "ON".
2.
Remove front lid.
3.
Load "Minute Pak
®
”.
Thoroughly shake "Minute Pak
®
” before loading.
4.
Install check valve into package.
5.
Press red "Reset" Button.
6.
Replace front lid.
7.
Prime pump by dispensing until product is dispensed.
B. Intermittent Lockout
Every precaution has been taken to produce a Sold Out Feature which will operate properly with all of the
Minute Maid
®
products. However, it is possible that an individual machine may lockout inadvertently.
Should the machine lockout while product remains, simply press the "Reset" button.
If the machine continues to lockout, check the condition of the concentrate tubes. If the tubes are heavily
stained from the product, the tube(s)
must
be changed out.
C. Test Procedure
Should you desire to determine if the Sold Out Feature is working, you may perform the following
procedure:
1.
Load Product into machine.
2.
Press "Reset" button.
3.
Dispense for 20 continuous seconds.
NOTE:
The 20 second continuous dispense is
ONLY
required for testing.
4.
The Sold Out Feature should now be armed. To test, remove the check valve from the
concentrate package. Then dispense until lockout alarm sounds (this simulates an empty
package).
5.
When alarm sounds, press "Reset" button to return to monitoring condition.
6.
If alarm does not sound, repeat test procedure. If alarm does not sound after repeating the
test procedure several times, contact the Service Center.
D. Disabling of Sold Out Feature
The Sold Out Feature can be disabled by pressing the "Flush" button three (3) times (in rapid succession).
The dispenser will follow with three (3) short beeps.
E. Enabling of Sold Out Feature
Press the "Reset" button to enable the Sold Out Feature. Dispenser will follow with three (3) short beeps.
2.3
CLEANING AND SANITIZING INSTRUCTIONS
For optimum dispenser performance and highest drink quality, please follow the instructions listed
below for cleaning your dispenser. The instructions are also shown on the inside front cover for the
Escort Dispenser.
CAUTION
DO NOT USE ANY POWDERS OR ABRASIVE CLEANING COMPOUNDS THAT WILL DAMAGE
FINISH.
A. Daily
1.
Flush each valve of dispenser until clear water flows from the nozzle.
4
dinecompany.com