1. INSTALLATION
BEFORE gETTINg STARTED
Each unit is tested under operating conditions and is thoroughly inspected before shipment. At the time
of shipment, the carrier accepts responsibility for the unit. Upon receiving the unit, carefully inspect the
carton for visible damage. If damage exists, have the carrier note the damage on the freight bill and
file a claim with carrier. Responsibility for damage to the dispenser lies with the carrier.
THINgS TO CONSIDER:
Connecting lines can be run through the back of the dispenser or extend down through a counter
cutout. Seal the dispenser directly on the countertop.
1.1 UNpACKINg THE DISpENSER
A. Set shipping carton upright on the floor. Cut band and remove. Open top of carton and remove
interior packing.
B. Lift carton up and off of the dispenser. Remove wood shipping base from the bottom of the
dispenser. (Support dispenser while removing shipping base to prevent damage to the dispenser.)
C. Remove installation parts kits from the ice compartment.
D. Inspect unit and parts for concealed damage(s). If damage exists, notify delivering carrier and
file a claim against same.
1.2 DRAIN SpIDER
The drain spider (Fig 1) is located directly in the center of the bin under the
ice shroud. The coldplate has a cavity designed to hold the drain spider.
During shipment or installation, the drain spider may become dislodged from
its original position.
Prior to installing the dispenser, ensure the drain spider is in the correct
position.This will prevent drain clog issues. Inspect the lower bin area and
reach under the shroud to ensure the drain spider is secure in the
coldplate cutout. If the spider is not in place, proceed with the following steps:
A. Remove agitator clip and pin from agitator bar (Fig 2).
B. Remove agitator bar from paddle wheel.
C. Remove paddle wheel.
D. Remove ice shroud by lifting back then out of bin.
E. Locate drain spider and reinstall in the coldplate cavity where drain line exits.
F. Reinstall all components. Ensure agitator clip is locked.
_______________________________________________________________
FIgURE 1
IBD 4500/4600/LCD
10
FIgURE 2
Summary of Contents for 4400 Series
