• Make sure that the power cable and mains
adapter plug do not come into contact
with water, steam or other liquids.
• Do not attempt to retrieve a de-
vice that has fallen into water.
• Unplug it immediately from
the mains power supply.
report_problem
Repairs
• The device should not be opened.
• Only a specialist may repair electrical devices.
Any inappropriate repair may cause a signifi-
cant risk to the user. Contact customer service
or an authorised dealer for any repairs. Do
not try to maintain the oximeter unless you
are a qualified professional. Only qualified
maintenance professionals are authorised to
carry out internal maintenance if necessary.
Fire hazard
• Any inappropriate use or use that
does not comply with these operating
instructions may cause a fire hazard!
• Do not use the device in a covered area,
under a cover or under cushions, for example.
• Do not use the device close to
highly inflammable materials.
• Make sure that the air vents are not covered.
• Never disconnect the device when it is
switched on. Always stop it beforehand.
• Do not expose the device to
high temperatures.
Note
• The product must be cleaned after use to pre-
vent grease and other residues accumulating.
5. PRODUCT DESCRIPTION [
insert_photo
1]
1 Cosmetic cotton retaining ring
2 Electrode
3 Ultrasonic head
4 Blue-red LED
5 On/off button and intensity
6 Mode Button
7 Electrode
8 “Cleaning” mode
9 “Nourishing” mode
10 “Lifting” mode
11 “Soothing” mode
12 “Massage” mode
13 “Photon” mode
14 Charging port
6. INSTRUCTIONS FOR USE
Charging
1 Please charge the product before using
it for the first time. Make sure you use
the charger according to the require-
ments below. If you use it abroad, first
check whether the country’s voltage and
charger are suitable for this product.
2 Turn off the product first when charging.
Connect the charger to the USB cable
that is included. Insert the charger into
the mains power supply and connect
the product to the USB charger cable.
3 The indicators of the different programmes
will start to flash (“C” and “P” then “N”
and “M” and finally “L” and “S”), showing
that charging is in progress. Once the
charging process ends, all the lights will
be lit and permanently on. At this point,
disconnect the product from the USB
cable and disconnect the charger from
the power supply. It’s quite normal for the
product and charger to be slightly warm.
4 Approximately two hours are need-
ed to charge the product fully using
the charger that meets the require-
ments. The time may vary depending
on the specific circumstances.
report_problem
Warning
Do not insert or remove the power cable with wet
hands (this may cause an electric shock and the
product to short-circuit.
E-IM-Pureskin-002.indd 5
E-IM-Pureskin-002.indd 5
11/06/2021 16:37:31
11/06/2021 16:37:31
