10
General Information
Using these instructions
The figures and letters in brackets (1), (2), (3), (4), (5), (6), (7), (8), (A)
and (B) relate directly to the picture of the front panel. They identify the
part on which the specified action is to be performed or on which a reaction
can be seen.
The lines in ordinary typeface below the procedural instruction describe
the reaction of the system or unit following the operation.
The figures at the right-hand margin denote a paragraph in the
"Fault Correction” section of these instructions. If the reaction indicated
does not occur, please refer to this. It describes the possible causes of
faults and how to rectify them.
___________________________________________________________________
The word in italics between two lines and the sign
are notes for a better understanding of the operation or notes on how to
avoid incorrect operation.
___________________________________________________________________
___________________________________________________________________
The lines in bold italics between two lines and the triangle
draw attention to dangers. The instructions given there must be followed.
___________________________________________________________________
If you now follow the operations step by step, paying attention to the
instructions, you will automatically be working correctly.
If any of the reactions indicated do not occur, there is a fault with the unit or
the system. You should correct the fault first before proceeding.
Fault correction
Follow the instructions identified by the figures given after the fault codes
and after the procedural instructions. You may find the solution to your
problem there.
This section, however, makes no claim to completeness. Should the
actions described there not have the desired effect, the unit or parts of the
unit (e.g. front panel etc.) must be changed. If the fault still occurs you are
dealing with a fault specific to the system.
___________________________________________________________________
Tip:
You can download the up-to-date version of these instructions from
http://www.lamtec.de as PDF File.
You will find the version from the letter of the booklet no.
(see the backside of this document).
Example:
DLT 6066 cD
booklet No. version language
___________________________________________________________________
CHANNEL 1
CHANNEL 2 CHANNEL 3 CHANNEL 4
ENTER
POWER
OIL
GAS
ALARM
SETPOINT
FEEDBACK
SETPOINT
FEEDBACK
ACTUAL VALUE
FEEDBACK
ACTUAL VALUE
FEEDBACK
SETPOINT
CHANNEL 5
x
x
x
5
4
6
A
B
7
8
3
SETTING
AUTOMATIC
CLEAR
MEMORY
O -CONTROL
2
PARAMETERISATION
MONITORIN
DISPLAY
FEUERUNGS-MANAGEMENT-SYSTEM FMS
LAMTEC
LAMTEC
x
2
1
DISPLAY CHANNEL 5
(DIGITAL INPUTS)
LOAD RATING
(CORR. INPUT)
STATUS
(CORR. RANGE)
SETPOINT
ii
i
!
i
