11_
LAMONA
Appliances
1. Burner cap
2. Burner crown
3. Ignition candle
4. Thermocouple
3
4
2
1
incorrect
burner cap not central
incorrect
angled
correct
parallel
burner cap
burner head
Burner Caps
CAUTION: Any cleaning agent used incorrectly
may damage the hob. Always let the hob cool
before cleaning.
Burner caps and heads
IMPORTANT: Allow burners to cool before
cleaning.
CAUTION: Hotplate burners can be damaged by
soaking, automatic dishwashers (or dishwasher
powders / liquids, caustic pastes, hard implements,
coarse wire wool, and abrasive cleaning pastes.
Clean with a moist soapy pad. For the burners to
work safely, the slots in the burner head where the
fl ames burn need to be kept clear of deposit. Clean
with a nylon brush, rinse and dry thoroughly.
IMPORTANT:
The burner caps and heads must be
repositioned correctly so that they sit squarely onto
the hob as shown below.
This is particularly important with stainless steel
models as failure to reposition the caps correctly
may result in discolouration of the stainless steel
around the burners.
In case of fl ame failures of the burners for any
reason, the fl ame failure sensor ‘A’ will cut off the
gas fl ow after a few seconds.
If this occurs, depress and turn the control knob to
the ignition position clockwise direction and wait for
ignition.
Keep the knob at pressed position for 3-5 seconds
after you see the fl ame around the burner.
Repeat the sequence of operations if the fl ame
does not continue.
After you release the knob, if the ignition does not
continue repeat the same process by keeping the
knob pressed for 15 seconds.
DANGER:
Risk of fi re in case of unburned gas!
Do not press the knob for longer than 15 seconds
if there was no ignition. Wait for one minute and
then repeat the ignition process.