8
.
,
.
ASSEMBLING THE TABLE SAW
INSTALL THE TABLE EXTENSION WINGS
Attach the table extension wings to the
main table using 8x12mm hex head bolts
(4 per wing), and 8 lock washers. Align the
table extensions with the table and
loosely attach the bolts. Place a
straightedge on the table and extension
as shown to align the extension table and
then tighten down the bolts.
Note: Be sure that the table extension
wings are flush with front edge.
MOUNT FENCE STORAGE BRACKETS
The miter gauge and arbor wrench storage
brackets are already installed on the saw.
Install the fence storage brackets on the right
side of the saw as shown in using two Phillips
head screws and flat washers.
FRONT RAIL INSTALATION
Note: The 36” front rail has 2 pieces of
Tubes & a join pin but 52” Rail is single
piece.
1. Loosely thread the six square head bolts
to the front of the table.
2. Do not tighten down the nuts. Leave the
square heads of the bolt protruding from
the table
3. From the left side of the saw, slide the
upper slot of the left (shorter) front rail
onto the square head bolts
4. Set the left end of the rail flush to the outside
edge of the extension wing.
Summary of Contents for MTSAW17536110-0130
