laguna MTSAW17536110-0130, Manual

Page: 17 / 35

16
MAINTENANCE & ADJUSTMENTS
PERIODIC MAINTENANCE
• Inspect/test the ON/OFF switch before
each use. Do not operate the saw with a
damaged switch - replace a damaged
switch immediately
• Inspect the saw blade for damage or
chipped teeth before each use.
Replace a damaged or chipped blade
immediately. Never operate the saw
with a damaged or chipped blade
• Keep the saw table clean and free of dust,
pitch or glue. An occasional light coating
of paste wax can be use to protect the
cast-iron surface. Ask our local distributor
for suggestions on table top cleaners and
cast-iron surface protection, based on
what is readily available in your area.
• Occasionally open the cabinet door and
brush off and vacuum out accumulated
dust from inside the cabinet and on the
blade tilting gears and on or around the
motor.
• Periodically inspect the power cord
and plug for damage. To minimize the
risk of electric shock or fire, never
operate the saw with a damaged
power cord or plug. Replace a
damaged power cord or plug at the
first sign of damage.
• To minimize airborne dust particles
periodically inspect all dust collection
fittings – retighten as needed.
WARNING:
MAKE SURE THE SAW HAS
BEEN TURNED OFF AND UNPLUGGED FROM
THE POWER SOURCE BEFORE PERFORMING
ANY MAINTENANCE.
LUBRICATION
Keep the blade height screw A (under the
table on the left side) as well as the blade tilt
screw B (under the table on the right side)
well lubricated and free of dust or debris.
Clean and remove dust, debris, and old
lubricant as needed depending on frequency
of use.
After cleaning, reapply lubricant as needed.
Note: Use any all-purpose grease, available.
The motor and all bearings are sealed and
permanently lubricated, no further
lubrication is required. No other part of this
table saw needs lubrication.
REMOVE THE MOTOR COVER FOR SCREW A
REMOVE THE SIDE COVER FOR SCREW B
!
！