9
.
5. From the right side of the saw, slide the
upper slot of the right front rail onto the
square head bolts (for 36” rail only)
6. Fit the 2 rails together(for 36” rail only)
7. Tighten down the nuts to firmly secure the
front rails to the table.
REAR RAIL INSTALLED
36” rear rail with 2 pieces of rail but 52” Rail
is single piece.
1.
Use 6 cap screws with lock washers and
nuts to assemble the rear rails to the rear
of the saw as shown
2. Make sure that the intersection between
the two rear rails is leveled (for 36” rail
only)
RIGTH TABLE OF 52” RAIL INSTALLED
1. Assemble the right table assembly to the
extension table and
align
to the front rail
mounting holes. Fasten the table to the
front rail with two M8 hex bolts, 8 mm flat
washers, and M8 hex nuts. Fasten the
table to the rear rail with two CAP screw w/
lock washers, 8 mm flat washers, and M8
hex nuts.
.
2. Install each foot with a M8 Hex nut A into
the bottom of a support leg.
3. Fasten support leg to the main extension
table on front rail with two M8 hex bolts,
8 mm flat washers, M8 hex nuts and f two
cap screw w/ lock washers, 8 mm flat
washers, and M8 hex nuts on rear rail.,
then rotate both feet until they touch the
ground, and tighten the hex nuts against
the support legs to secure the feet.
Make Lever Here
A
Summary of Contents for MTSAW17536110-0130
