3
17.
Avoid working from awkward or off balance positions. Do not overreach while cutting; keep
both feet on floor. Never lean over or reach over the blade and never pull the work piece
over the blade from behind.
18.
Use out feed support or have an assistant help when ripping long material.
19.
Keep blade guards in place and in working order. If a guard must be removed for
maintenance or cleaning, be sure it is properly reattached before using the tool again.
Never leave the machine running with the power on when not in operation.
Don't leave tool until it comes to a complete stop.
20.
Use of parts and accessories NOT recommended by supplier may result in equipment
malfunction or risk of injury.
21.
Never stand on machinery. Serious injury could result if the tool is tipped over or if the blade
is unintentionally contacted.
22.
Always disconnect tool from power before servicing or changing accessories such as blades,
or before performing any maintenance, cleaning or adjustments, or if the machine will be left
unattended.
23.
Make sure that switch is in "OFF" position before plugging in the power cord.
24.
Make sure the tool is properly grounded. If equipped with a 3-prong plug it should be used
with a three-pole receptacle. Never remove the third prong.
25.
Do not use this saw for other than its intended use. If used for other purposes, we disclaims
any real implied warranty and holds itself harmless for any injury, which may result from that
use
.
26.
Before using the machine, Check that no guard or other part is damaged. Carefully check
to determine that all parts of the machine will operate properly and perform there intended
function. Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
CAUTION: This means that if precautions are not heeded, it may result in minor or moderate injury and/or
possible machine damage
WARNING: This means that if precautions are not heeded, it could result in serious injury or possibly even
death.
WARNING:
T
he operation of any power tool can result in foreign objects being thrown into your eyes,
which can result in severe eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with
side shields. Always use eye protection which is marked to comply with ANSI Z87.1.
Summary of Contents for MTSAW17536110-0130
