laguna MTSAW17536110-0130, Manual

Page: 11 / 35

10
FITTING THE START /STOP SWITCH
The Switch box assembly slides onto the rail
slot and can be adjusted to any position to suit
you, but it is suggested that it is close to the
end of the aluminum rail.
Once in position clamp in position by
tightening the nuts.
INSTALL BLADE GUARD
The blade guard assembly consists of the
clear polycarbonate shield, the spreader
and anti-kickback pawls on each side.
1.
Disconnect saw from power!
2.
Remover the table insert.
3.
Insert the spreader into the bracket slot and
tighten the lock knob shown to secure the
spreader.
4.
Tug the spreader up to verify it is locked.
5.
Lift the blade guard cover just enough to
slide the table insert into the table slot
over the blade, then secure the insert with
the knob on the front of the insert. The
guard should swing up high enough to
accommodate the work piece.
6. Lifting up the right spreader pawl, place a
straightedge against the blade and the
spreader.
When properly aligned the spreader/riving
knife will be in the "alignment zone," shown
in Fig. 3, and will be parallel with the
blade.
Fig. 3