laguna MTSAW17536110-0130, Manual

Page: 13 / 35

12
TABLE INSERT
See Fig. 8
To install the zero clearance insert:
1. Disconnect saw from power!
2. Check to make sure the blade is properly
installed.
3. Install the table insert
4. Adjust the table insert set screws with a
2.5mm hex wrench to make sure the insert
is flush with the table then turn the lock knob
to secure the insert.
5. Turn ON the saw.
6. Set the blade angle at 45° then slowly raise
the blade to the maximum
7. Set the blade angle at 0° then slowly raise
the blade to the maximum height that will be
used during normal operations.
8. Use a straightedge to determine whether the
insert is level with the table top [see Fig.9].
To adjust, turn each of the 5 adjusting
screws with the allen wrench until level.
SAW BLADE
See Fig. 10
This saw can take a blade with 10"
(250mm) diameter having a center hole
diameter of 5/8". Be sure to disconnect
table saw from power source before
changing the blade.
1. Set the blade to 90º and raise it to its
highest position.
2. Loosen the Knob Fig.11 on the Table Insert,
then remove the table insert and blade
guard/riving knife, depending on what is
installed.
3. Use the arbor wrenches loosen and remove
the arbor nut, flange, and blade.
Note: Loosen the arbor nut by rotating
counter clockwise .
4. Slide the blade over the arbor with the teeth
facing the front of the saw. Re-install the
arbor flange and arbor nut, and tighten them
against the blade. Do not over tighten.
5. Re-install the blade guard/riving knife and
table insert.
WARNING: ALWAYS TURN OFF AND
UNPLUG THE SAW BEFORE REMOVING/
INSTALLING A BLADE.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
!
！