A1. Parameters
23
A1
. P
ar
am
et
er
s
CO2 Laser Machine © 2018 Laguna Tools 8/27/2018
EN
40 Watt
60 Watt
80 Watt
120 Watt
Cut with the grain when possible. Consider that the density and water content of the wood will play a role in the
above parameters. Do not process woods with flammable surface finishes like lacquer or varnish.
Rubber
Silicone, Vulcanized Rubber, Polyurethane, Neoprene, Gaskets, Rubber
vibration mats, Rubber stamps
Engrave
100 - 80%
200 - 80%
325 – 80%
400 – 80%
Cut
50 - 100%
80 - 100%
120 – 100%
150 – 100%
Fabric
Polyester, Nylon, Leather, Denim, Netting, Neoprene, Cotton.
Cut/Engrave
450 - 20%
450 - 20%
450 - 15%
450 - 15%
Paper (thin materials)
Cut/Engrave
500 - 10%
500 - 10%
500 - 10%
500 - 10%
When cutting paper, be very cautious of the fire danger. Achieve laser settings such that the laser cuts the
material as quickly as possible without leaving burn marks.
A2. Parts
WARNING!
WARNING!
Never perform and setup, maintenance or adjustments with the machine connected to the power
source!
NOTICE!
Only use authentic Laguna Tools parts for replacements.
See Specifications here:
1.1 Specifications
Customer Support: (949)-474-1200 or
A3. Wiring
WARNING!
VOLTAGE.
Before connecting this tool to a power supply (receptacle, outlet, etc.) make sure that the voltage
supplied is the same that is specified on the nameplate of the tool. IF IN DOUBT, DO NOT PLUG IN THE MACHINE.
Using this tool with a voltage different than that stated on the nameplate can damage the electrical components
of this machine and any such damage will not be covered by a warranty.
CIRCUIT BREAKER.
Also make sure that the power supply is equipped with the appropriate breaker and plug
according to your local electrical code. To do this, first check the motor plate to get the FLA amperage of the
machine, if worn out or not present refer to the specifications sheet. If there is any doubt in choosing the
appropriate circuit breaker, please consult an electrician or an electrical supply source.
ELECTRICAL SHOCK.
It is extremely dangerous to work on live wires and/or electrical systems that are
connected to a power source.
ALWAYS
disconnect the power from the machine prior to performing any
maintenance or adjustments work.
MOTOR WIRING:
The information in this manual was current at the time of printing but may be different than the
diagram on your machine.
ALWAYS
use the supplied wiring diagram with the machine or motor (under the
electrical covering) if present.
See Electrical Specifications here:
1.1 Specifications
Customer Support: (949)-474-1200 or
5
5
