10
2. Setup
CO2 Laser Machine © 2018 Laguna Tools 8/27/2018
2.
S
et
up
EN
2. Setup
WARNING!
WARNING!
Never perform any setup, maintenance or adjustments with the machine connected to the power
source!
WARNING!
If you have any doubt about the described procedure, seek professional assistance. Do not attempt
any procedure that you feel is unsafe, or that you do not have the physical capability of achieving.
WARNING!
Only operate the Laser machine after proper installation of the Chiller, Air Pump, & Exhaust System.
Never operate machine without all systems running.
WARNING!
When removing packaging banding, extreme caution must be used as the banding will spring when
cut.
CAUTION!
The machine is heavy. Ensure that you have enough people to do the job safely.
CAUTION!
Use extreme caution when handling the fragile glass laser tube.
NOTE:
There may be sawdust in or around your new machine as a result of thorough testing before shipping.
The machine comes as assembled as possible without impacting shipping costs
and the possibility of damage. Because of this, there will always be some setup
procedures and adjustments that the craftsman must perform prior to using the
machine. Those setup sections that must be done to complete the assembly of the
machine are in the Machine Setup sub-section. Those help topics for making
operational changes to the machine in order to set up for a different function are in
the Functional Setup Section. All help topic pertaining to the proper set-up of
Accessories and Auxiliary Equipment are in the respective categories.
If you are looking for adjustments, like how to replace belts or align the mirrors,
please navigate to the
Maintenance Sections
.
2. Setup Contents
2.1 Preparing For Setup
2.2 Connection Diagrams
2.3 Unboxing & Inventory
2.4 Machine Set-Up
2.5 Auxiliary Equipment Set-Up
Exhaust Ventilation
Water Chiller & Pump
Air Compressor
2.6 Software Set-Up & Installation
2.1 Preparing For Setup
Receiving
It is likely that your machine will be delivered by a third party. Before unboxing, be
sure to inspect the packaging and shipping documents supplied by the driver.
Ensure that there is no visible damage to the shipment. If any damage has occurred
because of shipment, note the damage on the bill of lading or refuse the shipment.
Immediately call the dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying the
shipping company and the purchasing store.
Placement
Prior to removing the machine from the packaging, decide the operating location of
the machine. The dimensions and floor space can be found here:
Dimensions
.
1. There should be sufficient area at the front of the machine to allow you to work
on it comfortably.
2. There should be sufficient area at the back of the machine to allow access for
adjustments and maintenance to be conducted.
3. Adequate lighting. The better the lighting the more accurately and safely you
will be able to work.
4. Solid floor. You should select a solid flat floor, preferably one made of concrete
or something similar.
5. Locate it close to a power source and dust collection or fume extraction.
Unboxing
Once in place, carefully unbox and remove all components. Do not unpack the laser
tube until prompted in the setup procedures. Unboxing guidelines:
1. Do not cut deep into a box with a brazer blade as it could scratch the paint.
Only cut deep enough to cut the tape or use a dull edge.
2. Organize the hardware and setup tools needed (at beginning of each setup
section) prior to proceeding with setup.
17
10
11
12
13
15
15
16
16
16
7
