Lagler HUMMEL, Operation Maintenance Safety

Page: 23 / 48

23
EXCHANGING THE BACK WHEEL
6.6.3 EXCHANGING THE BACK WHEEL
(WHEEL ONLY OR WHEEL ASSEMBLY)
Use exclusively original LÄGLER back wheels (Art. no. in Section
10 ).
1 Switch off the machine and pull the plug out of the socket!
2 Tilt the machine forward over the bracket. Ensure that the
machine is standing securely!
Rear wheel only:
3 Release the screw in the centre of the wheel and remove the
screw, washers and nut (Fig. 46). Ensure that you do not lose
the nut.
4 Pull the back wheel off the tail axle housing.
5 Push the new back wheel onto the tail axle housing.
6 Insert the nut in the hexagonal recess of the tail housing and
hold onto the nut. Mount the washers and the screw.
Complete rear wheel assembly:
7 If you wish to exchange the complete back wheel with tail
housing, release the screw which fastens the tail axle of the
rear wheel in the machine housing (Fig. 47).
8 Pull the tail axle with the tail housing out of the borehole in
the housing (Fig. 47).
9 Mount the complete new back wheel in reverse sequence and
fasten it again in the machine housing, aligning the clamping
surface of the tail axle towards the screw (Fig. 47).
Fig. 46 Tilt the machine forwards over the bracket. Re-
move the screw with the washers and nut in the
centre of the wheel and take off the back wheel.
Assemble in reverse sequence.
Ensure that the
machine is standing securely!
Fig. 47 Tilt the machine forwards over the bracket and
release the holding screw. When mounting, align
the tensioning surface of the tail axle towards
the screw.
Ensure that the machine is standing
securely!
6