Lagler HUMMEL, Operation Maintenance Safety

Page: 8 / 48

8
COMMISSIONING
Commissioning
This section describes the procedure for commissioning the
HUMMEL on site. In order to exclude the possibility of damage and
malfunctions, it is essential to proceed in the sequence outlined
below.
Before working with the machine for the first time, operating staff
must be adequately instructed!
3.1 PREPARING THE MACHINE FOR OPERATION
1 Unpack the machine carefully. The bottom part of the sup-
plied transport crate makes a useful container for storage or
transportation of the machine (see Section 5, Transport and
storage). Please ensure that the packaging materials are
responsibly disposed of.
2 Press the lowering lever downwards, insert the guide tube
into the opening in the housing and at the same time place
the top part of the lowering rod linkage into the bottom part
of the rod linkage in the machine housing (Fig. 2).
3 Tighten the wing screw and the wing nut (Figs. 3 and 4).
4 Lift the sanding drum off the floor by turning the lowering lever
upwards.
5 Mount the cable support onto the provided bracket at the top
of the guide tube (Fig. 5)
6 Fasten the dust bag firmly using the cord and the MultiClip at
the end of the guide tube, ensuring when mounting that the
opening of the guide tube is not closed (Fig. 6).
7 Release the cover lock and remove the side cover on the right
of the machine housing (Fig. 7).
8 To engage the sanding belt, pull the opposite lever upwards.
This will lower the tensioning roller (Fig. 7).
Fig. 2 When inserting the guide tube, make sure that the
rod linkage of the lowering mechanism feeds in
correctly!
Fig. 3 After inserting the guide tube, carefully tighten
the wing screw and …
Fig. 4 … the wing nuts.
Fig. 5 Suspend the cable support into the provided
hole.
3