10
Install the handling cart [1]
on the front post of the rack
, m
aking sure that the lifting
handle
[8]
is turned inwards
, and lock it in position in correspondence with hole 1
using the trolley locking pin [4] .
Screw the tightening knob [7] into the appropriate hole without tightening it.
As shown in the figure, insert a sliding roller on bearings [5] into the lower holes of
the carriage, paying attention to pass the threaded pin inside the metal bushings.
Tighten the screws.
x2 x2 x1
n 16
x2
Nut
Threaded pin
Bushing
4
1
7
8
5
M10
