14
Once the installation of the tilting arm [9] has been completed,
carry out a second check of the sliding fluidity of the carriage by
repeating the steps seen in point 4.
Then check the fluidity of movement of the rocker arm, lifting it
and making it return freely to the starting position. If the screws
are correctly tightened, the arm will return to a parallel position
with the rack post, after a first collision against it.
If it stops before, on the other hand, it means that the plates of
the handling trolley are too tight, just slightly loosen the screws
of the front sliding rollers to solve the problem.
Repeat these checks several times by slightly loosening or
tightening the screws and dowels until you have the maximum
fluidity of movement of the carriage and the tilting arm.
n 16
x2
n 3
x1
DANGER MOVING PARTS
Danger of crushing and trapping of fingers
between the rocker arm, pins, holes and rollers
during use, check and adjustment of the tool.
ATTENTION:
Even in training,
handling and adjustment of the trolley must
always take place in the absence of the training handle [12] in
order to lighten the equipment as much as possible and move it
more easily.
9
