LM1510 Servo Drive Label Applicator
US
ER’S MANUAL
Page
9
Made in the U.S.A.
© 2019 LabelMill
11/01/2019 Model LM1510
WEB ROUTING
(Left Hand Tamp Configuration Shown)
Step
Operation
1
Load web onto label storage spool (A) so it unloads in a counter-clockwise direction.
2
Feed the web to the left and under the guide roller (B).
3
Then to the right and under the brake arm (C).
3
Insert the web above the first guide roller (D) and under the second guide roller (E).
4
Wrap the web around the peeler plate (F), continuing on under roller (G).
5
Feed the web over the top of drive roller (H). Next, slip the web between the drive roller
and the pinch roller (I). Continue on by wrapping the web under the pinch roller.
6
Finish the process by loading the waste backing paper onto the web take-up spool (J).
Install the take-up spool clip over the end of the waste backing paper. The take-up spool
rotates in a clockwise direction.
7
Adjust the plastic web guide clips so the web is guided straight and even. Make sure the
clips do not bind the web.
** To remove the label storage spool (A), turn the spool lock counter-clockwise until you reach a stop. The spool
will now slide off. To secure the spool, simply turn the spool lock clockwise until snug. DO NOT over tighten!
2-2
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
