LM1510 Servo Drive Label Applicator
USER’S MANUAL
Page
16
Made in the U.S.A.
© 2019 LabelMill
11/01/2019 Model LM1510
Tamp Assembly & Factory Setup
NOTE: PICTURES SHOWN MAY NOT RESEMBLE YOUR MODEL
Tamp pad adjustment
1. To adjust the tamp pad (T) in relationship to the peeler plate (P) in the horizontal plain, loosen the (2) button-
head screws and move the peeler plate forward or backward in the slots. There should be approximately
0
.020” (A) gap between the tamp pad (T) and the peeler plate (P).
2. To adjust the tamp pad (T) in relationship to the peeler plate (P) in the vertical position, loosen the hinge
thumbscrew, swing the tamp assembly out, and loosen the (4) cap head bolts that secure the tamp mount
assembly in place. Adjust the up
or down to achieve the 0.020”, tighten the (4) bolts, and secure the tamp
assembly in place by tightening the thumbscrew. This adjustment is very important! If this is not adjusted
properly, the label will run into the back of the tamp pad (T) and fold or bunch up.
Air assist tube adjustment
1. Adjust the air assist tube (B) so that the small holes aim towards the center of the tamp pad. The air assist
tube (B) aids the label to adhere to the bottom of the tamp pad (T). Once the label (L) is “blown” onto the tamp
pad (T), it is held there by vacuum.
2. Once the above adjustments are made, adjust the vacuum regulator, the air assist regulator, and the flow
controls as described on page 3-1.
Note: Too much pressure on the air assist will cause the label to flutter and/or blow off of the vacuum platen.
3-2
Tamp Pad (T)
Air Assist Tube (B)
Peeler Plate (P)
Hinge
Thumbscrew
