39
20) FUNCTIONS AND SETTINGS
To enter, type 10-character technical password (for more information, refer to “Password management” paragraph)
The buttons in this sub-menu are used as follows:
button F2
= to access the F function setting (see the “Function setting” paragraph);
button
= to access the P parameter setting (see the “Parameter setting” paragraph);
button F1
= issue the door opening command;
button F3
= it is only used in case the ET-DSEL digital programmer is connected to two operators, to choose whether to act on the
functions and parameters of operator 1, or of operator 2. The number 1 or 2 at the top right of the display indicates the
selected operator. If the ET-DSEL programmer is connected to a single operator, the number 1 appears at the top right of the
display.
button
= to return to the general programming menu.
20.1)
FUNCTION SETTING
In this section the display describes the purpose of the selected function;
the F1 button sets the function status to OFF;
the F3 button sets the function status to ON;
the F2 button allows to switch to the next function;
the button allows to return to the previous function;
20.2)
PARAMETER SETTING
In this section the display describes the selected parameter type;
the F1 button decreases the set percentage value;
the F3 button increases the set percentage value;
the button allows to switch to the next parameter;
the F2 button allows to return to the previous parameter.
For information about the operation of each parameter, please refer to the "PARAMETER TABLE" below.