26
Main Menu
Second-Level
Menu
Third-Level
Menu
Default Value Setting Value
network
administrator.
Default
Gateway
192.168.0.1 Set
this
parameter based
on the address
assigned by the
network
administrator.
Table 15 – IP parameters
5.6.2 Setting Parameters before Using the SNMP Management
Procedure
Step 1
Apply to the site or equipment room network administrator for a fixed IP address.
Step 2
Set the IP address, subnet mask, and gateway on the LCD of the DCSC, as described in
Table 16.
Main Menu
Second-Level
Menu
Third-Level
Menu
Default Value Setting Value
Setting Wizard
Network
Parameters
IP Address
192.168.0.10
Set this
parameter based
on the address
assigned by the
network
administrator.
Subnet Mask
255.255.255.0
Set this
parameter based
on the address
assigned by the
network
administrator.
Default
Gateway
192.168.0.1 Set
this
parameter based
on the address
assigned by the
network
administrator.
Table 16 – IP parameters
Connect the network port on your laptop to the FE port on the DCSC by using a network cable.
CAUTION:
There is only one FE port on the DCSC. Before performing step 3, disconnect the original cable from the
FE port and then reconnect it after performing the following steps.
