MAINTENANCE
General cleaning
1. Before proceeding, ensure that the treadmill power is off and
that it is unplugged from the electrical outlet.
2. Remove dust, use a small vacuum nozzle to carefully vacuum
around all visual components.
3. To remove film or dirt use a slightly damp rag with a mild
cleaning agent only.
4. Be careful not to immerse any treadmill components with any
liquids.
Cleaning and inspecting the
running belt
Turn off the power and unplug from the electrical outlet. Carefully
position the treadmill on its side. Use a damp cloth to wipe off the
inside of the running belt. Carefully rotate the running belt by
hand to clean the entire inside surface. Return treadmill to its
upright position. If running belt edge is frayed, check the running
belts alignment. If seams are splitting, call your retailer or nearest
authorized service center.
Aligning the running belt
Ensure the running belt is centered on your treadmill at all times.
Running style and a non-level surface are two instances that may
cause the belt to drift off center. Minor adjustments to the two
bolts at the rear of the treadmill are necessary when the belt has
drifted off center.
1. Press “
START
” to begin running belt, then increase the
treadmills speed to 5 km/h (3mph).
2. Stand at the rear of the treadmill to determine which direction
the belt is drifting.
3. If the belt drifts to the left, turn the left adjustment bolt with #6
wrench a 1/4 of a turn clockwise. (FIG. C)
4. If the belt drifts to the right, turn the right adjustment bolt with #6
wrench a 1/4 of a turn clockwise. (FIG. D)
5. Observe the tracking of the belt for about 30 seconds. Repeat
previous steps if needed.
Inspecting fasteners and
cables
Check that all fasteners are properly tightened and all cables are
securely in place. To avoid damaging fasteners do not over
tighten.
Storage
Store your treadmill in a clean and dry environment. Ensure the
master power switch is off and is unplugged from the electrical
outlet.
Moving
The treadmill has been designed and equipped with wheels for
easy mobility. Before moving, ensure the master power switch is
in the “OFF” position and the power cord is unplugged. Lift the
base frame of the treadmill and then roll the treadmill to the
desired position.
Running belt lubrication
When you feel the noise of the running belt is louder, please use
the silicon spray on the running belt. It is easy and quick. Before
proceeding, ensure the treadmill power is off and unplugged.
Loosen the running belt and then spray the silicon on the inner
side of the running belt. Please see illustration. After spraying,
please align the running belt and adjust the running belt tension.
10
