72
Your basic operation is performed through one of two types of
thermostats shown.
Thermostat (below) on left is for coaches without central air and on the
right side is with central air conditioning,
Thermostat - with air conditioning
On the left side of the thermostat is where you control if you want heat or
cooling.
COOL - Cool air will be produced from air conditioner.
FAN - Fan only will be in operation. No heat or cooling.
OFF - Means all electrical current is turned off and nothing will operate
until power becomes available for heating or cooling.
HEAT - In this position, furnace will become active and place heat inside
of coach.
Slide the switch in the center of thermostat to set desired temperature.
On the right side is a switch for fan operation. There are 2 speeds for air
conditioner, either low or high speed. Furnace has only 1 speed.
Thermostat - without air conditioner
Upper left side has an on/off switch to engage electrical current for
operation. Same lever will also set temperature as desired.
From the time you turn the thermostat on, there is a delay built into the
furnace to perform a purge cycle preventing any possible propane vapor
buildup in the chamber.
Operating Instructions
1. Before using your furnace, it is suggested to open entrance door
and windows to air out camper for any unusual odors such as
propane.
2. Be sure propane container has fuel and valve is open.
3.
Release thermostat from “OFF” position and onto “HEAT”
position.
4. Set temperature 5 to 8 degrees above room temperature.
5. Blower will start within 15 seconds and run for 30 seconds during
