41
Either of these methods will help ensure maximum electrical power for
the slideout motor, as well as maintain your battery.
Electrical Components
A 12-volt DC motor is located between main rails of frame on below floor
system. On the above floor system, the motor will be under the floor of
the sofa or dinette.
Operational Switch: This switch is a three position, (off in center, in or out)
spring loaded switch. Select which direction you wish to move the room.
Press on desired position and hold until room is seated, and gasket is
slightly compressed. Do not force the room to move beyond sealing as
damage could occur.
Open:
Hold operation switch until room seals tightly on the exterior of the
unit. DO NOT distort or bend the interior fascia by holding the switch in
the “ON” position.
Close:
To retract, reverse the procedure and hold button until the room
is fully inside with gaskets sealing to the outer wall. It takes about 20
seconds to move slide in or out.
Schwintec Wall Slide
Schwintec system is composed of four tracks placed on the outer sidewall
of slide, two at the bottom and two near the roof line. On each side, an
extrusion is attached to the sidewall with a motor inside, at the top. A
gear is mounted to the motor that will run on the upper track to move the
slide in or out. There is a wire harness along the side of the extrusion.
Power is supplied by 12-volt DC, converter, and/or an auxiliary battery
through a module board located under the slide, near the slide in cabinet.
Operation error codes are listed and found in the manual supplied by the
manufacturer of the equipment.
It is VERY important to keep tracks clean and free of debris.
Each side has its own motor at the top of the extrusion, accessible only
on the inside of the coach.
Manual Override
A. Electric manual override.
1. Locate the circuit board.
2.
Press the “mode” button 6 times quickly, press a 7
th
time
and hold for approximately 5 seconds. The red and green
LED lights will begin to flash. This confirms the override
mode.
