39
closet and wardrobe slides.
Before operating the power slideout system in your coach, read and
become familiar with these instructions, along with components and
operation methods. Most of these components are inside of the enclosed
underbelly cover and cannot be seen.
Trailer Set Up Requirements
—General
1. Before operating the slideout room, level the trailer front to rear
and side to side.
2. Extend all stabilizer jacks to make solid contact with the ground
and/or on solid blocks. Placing stabilizer jacks onto a hard
surface allows the coach to remain square and assures a good
weather tight seal between the slideout and trailer sidewall.
Because operating the slideout draws up to 15 amp currents
from the battery, some source of supplemental charging
should be operating while extending or retracting the slideout.
Stand clear of the room’s interior path and verify that the
room’s exterior path is clear before extending or retracting.
Always make sure the trailer is level before operating slideout
room.
Always make sure there is no obstructions blocking the path
of the room when it is moving.
Always make sure the path is clear of people and objects
before operating.
Always keep away from the slide rails under the coach when
room is in motion.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN SERIOUS INJURY OR DEATH.
DO NOT tow trailer with the slideout in the OUT position. If
the trailer is towed with the slideout extended, the KZRV
Limited Warranty will be voided.
When opening the slideout, DO NOT over-extend. Fascia
board can be distorted, loosened, or bent.
