Kyocera TASKalfa 550c, Software Installation Manual

Page: 58 / 184

3 INSTALLING PRINTER DRIVERS FOR WINDOWS
56 Other Installations
„
Point and Print
This section describes how to set up the printer drivers by Point and Print.
y
It assumes using SMB printing by Point and Print in a small network. If you can use the Windows 2000, Windows
XP, Windows Vista, Windows Server 2003, or Windows Server 2008 as a print server, it is recommended to set up
for printing via Windows print server.
y
For installing the printer driver by Point and Print, the printer driver files for Point and Print must be uploaded in the
MFP. The printer driver files can be uploaded in the MFP using the administrative function of COMMAND CENTER.
For more information about Point and Print, please ask your network administrator.
Installing the printer drivers by Point and Print
The following describes an installation on Windows Vista. The procedure is the same when other versions of Windows are
used.
To perform installation, you must log into Windows as a user who has “Administrators” or “Power Users” privilege. In
case of Windows XP/Vista/Server 2003/Server 2008, only users with the administrator privilege can perform it.
For users without the administrator privilege on Windows Vista/Server 2008, installation is possible by entering the
administrator’s password in the dialog box for changing a user account at the time of installation and having the
administrator privilege temporarily.
1
Open this equipment in the network with Windows Explorer, and double-click a queue
in which the printer driver should be installed (see below).
pcl6 — Double-click this queue to install the PCL6 printer driver.
ps3 — Double-click this queue to install the PS3 printer driver.
y
The XPS printer cannot be installed using Point and Print from this equipment.
y
Configure the SMB settings and the NetBIOS name on COMMAND CENTER when using the computer
name of the MFP.
- When the SMB settings are set using IPv4: Configure the WINS server addresses and DNS settings on
COMMAND CENTER.
- When the SMB settings are set using IPv6: Enable the LLMNR setting or configure the DNS settings on
COMMAND CENTER.
For instructions on how to set them on COMMAND CENTER, refer to COMMAND CENTER Guide .