14
When This Message is Displayed…
Message
MEMORY OVER FLOW. PRESS
"CONTINUE" TO RESUME JOB.
DATA OVERRUN. PRESS
"CONTINUE" TO RESUME JOB.
PRINTER BOARD ERROR.
PRINTER BOARD ERROR.
EEPROM
PRINTER BOARD ERROR.
ROM CHECK-SUM.
PRINTER BOARD ERROR.
RAM
SYSTEM ERROR.
MAIN SWITCH OFF/ON.
PRINTER ERROR. PRESS COPY/PRINT
TO RESUME JOB.
The printer memory has become full during reception of data for a print job.
Press the displayed “CONTINUE” key to force-print the data onto multiple pages.
Printing could not be accomplished correctly because the print job contains
complex data that could not synchronise with the printer engine. Press the
displayed “CONTINUE” key to reprint the data.
Procedure
ADD PAPER IN DRAWER.
XX SIZE
PLACE PAPER ON BYPASS.
XX SIZE
The size of the original does not match the size of the paper loaded in the
drawer. Load paper of the size indicated into the drawer and press the displayed
“CONTINUE” key to reinitiate the print job. To cancel the print job, press the
“CANCEL JOB” key.
The size of the original does not match the size of the paper set in the stack
bypass tray. Remove the paper, readjust the insert guides and set paper of the
size indicated. Then press the displayed “CONTINUE” key to reinitiate the print
job. To cancel the print job, press the “CANCEL JOB” key.
There may be a problem with the Printer Board. Turn the main switch OFF and
then ON again, and then try to print one more time. If the error message remains
even after following the above procedure, contact your service representative, an
authorised service centre or the place of purchase.
If one of the following messages appears on the touch panel, verify the content of the message and perform the appropriate
procedure. At the same time, refer to the Instruction Handbook for your copier or the Instruction Handbook of any optional unit
that may be installed, as appropriate.
