KYMCO Super 8 50, Service Manual

Page: 49 / 185

4
. LUBRICATION SYSTEM
4-5
Super 8 50
Screw
Inner Rotor
Bolts
Pump Cover
Outer Rotor
Dowel Pin
Oil Pump
Arrow
Nut
Pump Driven Gear
ASSEMBLY
Install the outer rotor, inner rotor and pump
shaft into the pump body.
Install the dowel pin.
Install the pump cover by aligning the hole
in the cover with the dowel pin.
Tighten the screw to secure the pump cover.
Make sure that the pump shaft rotates freely
without binding.
INSTALLATION
Install the oil pump into the crankcase.
After the oil pump is installed, tighten the
two mounting bolts.
Install the pump driven gear and drive chain
by aligning the pump driven gear with the
cutout in the pump shaft.
Install and tighten the pump driven gear nut.
Torque : 1.0kg-m
Insert the pump shaft by aligning the flat
on the shaft with the flat in the inner
rotor.
＊
Install the oil pump with the arrow on the
pump body facing up and fill the oil
pump with engine oil before installation.
＊