KYMCO Super 8 50, Service Manual

Page: 166 / 185

15
. IGNITION SYSTEM
1
Super 8 50
SERVICE INFORMATION
GENERAL INSTRUCTIONS

Some electrical components may be damaged if terminals or connectors are connected or
disconnected while the ignition switch is
“ON” and current is present.

When servicing the ignition system, always follow the steps in the troubleshooting on page 17-2.

The ignition timing cannot be adjusted since the ignition control module is already adjusted in
factory.

The ignition control module or ECU maybe damaged if dropped or the connector is
disconnected when the key is
“
ON
”
, the excessive voltage may damage the ignition control
module or ECU. Always turn off the ignition switch before servicing.

A faulty ignition system is often related to poor connections. Check those connections before
proceeding.

Make sure the battery is adequately charged. Using the starter motor with weak battery results
in a slower engine cranking speed as well as no spark at the spark plug.

Use a spark plug of the correct heat range. Using spark plug with an incorrect heat range can
damage the engine.